FireClass

CTA Kit*

Name: CTA Kit*
Brand: FireClass
SKU: 517.050.060

رقم القطعة: 517.050.060

لا يعرض أي بائع سعرًا لهذا المنتج بعد. أرسل طلبك وسنعود إليك بأفضل عرض.

اطلب عرض سعر

يكتمل الطلب في تطبيق Ohmva بعد تسجيل الدخول.

الوصف

The Time Saver Ceiling Tile Adaptor is used with the 4B 4” detector base snap fit base and consists of three parts, a bezel and clamp that are fitted to the ceiling tile and a back-box that carries the detector and base assembly. Requires a 127mm diameter hole. The CTA adaptor plate allows this to be used with other devices such as the FC430SB. General Features: • Cuts installation time by 30%. • Commission the system before the suspended ceiling is installed. • Suitable for ceiling tiles from 1mm. • Made from flame retardant material. • No additional back-box is required. • Time saver is designed for use with a new snap-fit 4” detector base. • Adaptor available for use with the AV base & other devices.

المواصفات

FireClass Order Code	517.050.060
FireClass Range	FireClass Addressable Range
FireClass Category	Remote Indicators
Operating temperature	-25 - +70 (+90 for short periods)
DIMENSIONS (mm)	165x51.5H
WEIGHT (g)	232
Weatherproof wall units	These units are supplied with their own back box and special front cover. A sealing ring is supplied fitted on this front cover. See item 1 in Fig 4. 1 Fix the back box to the wall. Drill positions for glands on the top, bottom, and sides, see item 2 in Fig 4. 2 Slide the wall unit into place in the front cover as shown and then push down until it clips in. 3 Secure the front cover (including the wall unit) to the back box with the four supplied screws (M3.5 hex head) using the supplied Allen key. Note: To maintain the IP rating, use suitably rated cable glands and sealant as required.
Indoor wall units	1 Unclip the front cover from the wall unit. using the screw- driver slot on the top.The front cover is hinged at the bottom of the unit. 2 Use the two supplied screws to either fix the unit to the optional back box (with knockouts for conduit connections) or to the optional adaptor plate or to a back box with suitable mating fixings. 3 Refit the front cover, engaging the clips on the bottom first. 4 Secure the front cover with either the supplied self-tapping screw or nylon plug. Note: If using the adaptor plate a suitable recess is required for the connector block protruding from the rear of the wall unit.